100 units Basics BT
KEEP IN FREEZER UNITIL YOU USE IT...This is not the kit and does not come with the extras Basics BT is a purified protein that reduces wrinkles by relaxing the muscles that create them. This is only the BT in a sealed vial. This is not the kit.produced by the Clostridium bacterium(PRODUCED BY A CERTIFIED PHARMACEUTICAL COMPANY), which reduces the activity of the muscles contraction that cause those frown lines between the brows to form over time. You mix with 100 Units sterile water,slowly roll between palms to mix(DO NOT SHAKE). Storage It is widely believed that this product can not be stored or kept outside of its refrigerated state. Once BT is reconstituted, it must be kept refrigerated. However, if the product has not been reconstituted, it can stay at room temperature(in transit) without concern for up to 5 days. This information about the storage of this product is provided by THIS SITE, and is based on data that was provided to them by the manufacturer.
FOR NECK INJECTIONS WATCH THIS VIDEO
http://www.youtube.com/watch?v=FZCiRybSRxw
Recommendations for Reconstitution and Handling*
To reconstitute - remove tops of vials.
- Turn your saline upside down and insert syringe into the rubber. Withdrawal one full syringe of saline.
(1ml or also known as 100 units)
- The smaller vial is your Botulinum Cosmetic Basics BT. With this vial right side up insert the full syringe of saline into this vial. When you puncture the vial it will automatically withdrawal the saline into the vial. When the vial is full with the 1ml of saline your vial is ready to be mixed. Swirl, do not shake, until the powder is fully dissolved with the saline. This can take a few minutes. Your Botulinum Cosmetic Basics BT is now ready for treatment.
NOTE: You can mix your Botulinum Cosmetic Basics BT with 1, 2, 3, or 4 mls. However we recommend 1ml for exactly full strength, however full strength requires less units so be sure you administrator follows the exact recommendation of units as seen above.
| Diluent (saline) added to "Botulinum Cosmetic Basics BT" vial 100 units ONLY |
| 1.0 mL |
| 2.0 mL |
| 2.5 mL |
| 4.0 mL |
| 8.0 mL |
it is always recommended your treatments are minimal the first go so that you can avoid any unwanted side effects. If you feel after a couple of days that the effect was no acquired you have remaining solution in the fridge.
Storage
Botulinum Cosmetic Basics BT should be stored in the freezer before reconstitution. After mixing, it should be used at once or stored at refrigerator at 2 to 8c (Do NOT put into freezer after reconstitution) and to be used within 6 days ideally but Solution can remain effective up to 10 days in fridge.
NOTE: YOU SHOULD HAVE ALMOST 1/4 OF THE Botulinum Cosmetic BT REMAINING AFTER YOUR TREATMENT! NEVER EXCEED THE RECOMMENDED DOSAGES PER AS NOTED TO AVOID SIDE EFFECTS.
BE SURE YOUR DOSAGE NEVER EXCEED RECOMMENDED TO AVOID SIDE EFFECTS!
BE SURE YOUR ADMINISTRATOR DOES NOT INJECT JUST ABOVE THE EYEBROW AS THIS WILL RESULT IN A DROOPY EYE, (be sure to injection are 2cm above). ALWAYS ALWAYS BE SURE YOUR INJECTIONS ARE AT LEAST 2CM ABOVE THE EYEBROW. THIS WILL SUFFICE FOR FOREHEAD LINES.
| AREA |
Dose per site
|
No. of sites
|
Total dose per area
|
Injection depth
|
|
Forehead lines
|
2 ~ 4 Units
|
5
|
10 ~ 20 U
|
Subcutaneous / Intramuscular
|
|
Glabellar lines
(frown lines) |
4-5 Units
|
4 ~ 5
|
16 ~ 25 U
|
Subcutaneous / Intramuscular
|
|
Crow's feet
(each side) |
3 Units
|
3 ~ 6
|
6 ~ 18 U
|
Subcutaneous
|
Duration of effectiveness
The effect of Botulinum Cosmetic Basics BT usually lasts for 3 to 5 months, depending on individual response. The effectiveness of Botulinum Cosmetic Basics BT is maintained by injecting Botulinum Cosmetic Basics BT again before its effect expires.
